Table of Contents
Advertisement
Note: Only options 1, 2, v, p, q and r are applicable for the installer.
• q:
Close diagnostic program and start application
• r:
Restart Apollo
9.3 Environment settings
If option 1 is selected from the main menu of the Diagnostics program, it's possible to see and
set the environment options. The following options are relevant:
serial=12456749
mac address=00:1e:d1:10:1a:5d
ip=192.168.1.195
gateway=0.0.0.0
netmask=255.255.255.0
server=192.168.1.1
backup=0.0.0.0
port=0
dhcp=0
Hit any key to continue...
• ip:
the IP-address of the Apollo
• gateway:
the gateway address if the communication passes via a router
• netmask:
for a distinction between the local Ethernet traffic and Ethernet traffic via a
router.
• server:
the IP-address of the iProtect™ main server
• backup:
the IP-address of the iProtect™ backup server
• port:
port which is used for provisioning. (0=off and 6060=Default port)
• dhcp:
enable or disable use of dhcp. 0=disabled 1=enabled
Screen: changing environment ip setting
Enter new environment setting :
> ip=192.168.1.195
Screen: changing environment ip setting
Enter new environment setting :
> ip=192.168.1.195
OK : <IP=192.168.1.195>
Hit any key to continue...
Note: to activate these settings reboot the system. Use option (r) and do not
restart the Apollo by discharging the voltage.
--- Environment settings ---
--- Environment settings ---
--- Environment settings ---
Advertisement
Table of Contents
