Specifications - Sony STR-DE185 Operating Instructions Manual

Troubleshooting (continued)
The remote does not function.
• Point the remote at the remote sensor
receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace both batteries in the remote with new
ones, if they are weak.
• Make sure you select the correct function on the
remote.
• If the remote is set to operate the TV only, use
the remote to select a source or component other
than TV before operating the receiver or other
component.
Clearing the receiver's memory
To clear
All memorized settings
GB
22
g
on the
See
page 11

Specifications

AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
40 – 20,000 Hz; rated 100 watts per channel
minimum RMS power, with no more than
0.09 % total harmonic distortion from 250
milliwatts to rated output (Models of area code
U only).
Amplifier section
POWER OUTPUT
Models of area code U
Rated Power Output at Stereo Mode
(8 ohms 40 Hz – 20 kHz, THD 0.09 %)
Models of area code CEL, CEK
Rated Power Output at Stereo Mode
(8 ohms 1 kHz, THD 0.7 %)
1) Measured under the following conditions:
Area code
CEL, CEK
Frequency response
CD, MD/TAPE,
VIDEO 1, VIDEO 2
Inputs (Analog)
CD, MD/TAPE,
VIDEO 1, VIDEO 2
2) INPUT SHORT.
3) Weighted network, input level.
Outputs
MD/TAPE, VIDEO 1
Bass Boost:
Tone:
100 W + 100 W
1)
100 W + 100 W
Power requirements
230 V AC, 50 Hz
20 Hz – 50 kHz
+0/–0.5 dB (with bass
boost bypassed)
Sensitivity: 250 mV
Impedance: 50 kilohms
2)
S/N : 85 dB
(A, 250 mV 3) )
Voltage: 250 mV
Impedance: 10 kilohms
+8 dB at 70 Hz
±10 dB at 100 Hz and
10 kHz