Get Started; Charge Your Headphones - Philips ActionFit SH402 User Manual

3 Get started

Charge the battery
Note
 Before you use your headset for the
time, charge the battery for 5 hours for
optimum battery capacity and lifetime.
 Use only the original USB charging cable
to avoid any damage.
 Finish your call before charging the
headphones, as connecting the
headphones o .
 You can operate the headphones
normally during charging.
Connect the supplied USB charging
cable to:
• the micro USB charging slot on
the headphones and;
• the charger/USB port of a
computer.
LED turns white during
charging and turns o when the
headphones is fully charged
Tip
 Normally,a full charge takes 2 hours.
Pair the headphones with
your mobile phone
Before you use the headphones with
your mobile phone for the rst time,
pair it with a mobile phone. A successful
pairing establishes a unique encrypted
link between the headphones and
mobile phone. The headphones store
the last 8 devices in the memory. if you
try to pair more than 8 devices,the
4 EN
earliest paired device is replaced by the
new one.
1
Make sure that the heaphones are
2
Press and hold
3
Make sure that the mobile phone is
4
rst
The following example shows you
how to pair the headphones with your
mobile phone.
1
Activate the Bluetooth feature of
your mobile phone, select Philips
TASH402.
2
Enter the headset password"0000"
fully charged.
turn the headphones on.
turned on and its Bluetooth feature
is activated.
Pair the headphones with the
mobile phone. For detailed
information. refer to the user
manual of your mobile phone.
(4 zeros) if prompted. For those
mobile phones featuring Bluetooth
3.0 or higher, no need to enter a
password.
Philips TASH402
for 2 seconds to