Advertisement
6. Connect to your load positive to positive and negative to negative.
7. Turn on the output terminal again and check if display shows (CV).
8. If display shows (CC), either your pre-set current limiting value is too low or
your load requires more voltage and current. You need to re-access the volt-
age and current requirement of your load and increase the voltage or current
accordingly until (CV) appears.
Connecting the 3 outputs (using PSC-4136, 1-36V, 0.25-3A as an example)
All the three outputs are fully isolated from ground and with each other so that
it is possible to make cross connections to power a circuit board or device that
requires for example: +3 or +5V, +12 V or -12V and 1-36V as shown in Fig.1.
The variable main output is set for 12V and it is assigned as the +12V source
(available maximum current 3A) Note: the variable main output can be set for
other voltage (1-36V) such as 16V.
The fixed 12V is made as the - 12V source (available maximum current 0.5A)
The fixed 5V is made as the +5V source. (available maximum current 0.5A)
Figure 1 Diagram showing Circuit Board or Device
9
Advertisement
