Aquagem iSAVER Power+1100 Installation & User Manual page 5

Power plug
Above figure is for reference only, plug & socket may vary for different countries/regions.
If you do not require a power plug for installation, wire the device as shown in Fig.4, please.
Power source
220~240VAC,
1ph,50Hz
Earthing
Do not touch the heat sink while the device is in operation or until at least 30 mins
after it has been switched off. Keep it out of reach of children.
Because of high voltage conversion components contained in the device, do not try
to disassemble or replace any components in case of malfunction or breakdown.
Before serving on the unit, wait till the power light turned off or at least 3 minutes
after power plug has been plugged off from input supply.
Expansion plug
Screw
Pump socket
12mm
Screw
Power Cable
Breaker
(Customer prepare)
Fig. 3
Fig. 4
3