Table of Contents
Advertisement
AES67 MODE
The GS-MPI005HD MKII uses a chipset from Audinate called the Ultimo for its
®
network audio interface. Audinate are the company behind Dante
and as such the
primary network audio protocol is Dante®, however Audinate have enabled their chip
to comply with AES67 and therefore the GS-MPI005HD MKII can be set to AES67
mode for interaction with other AES67 devices.
Please note however that Glensound are relying on Audinate's AES67 interface and
are unfortunately not able to provide full AES67 support for the unit. AES67 support
should be sought directly from Audinate.
Turning On AES67 Mode
If you want to use your GS-MPI005HD MKII on an AES67 network and it has not
been set to AES67 mode then this can be set in Dante controller by double clicking
the MPI005HD to open the Device View window where you will find an AES67 tab to
enable AES67 support.
Once the AES67 drop down box has been enabled you'll have to reboot the
MPI005HD MKII for the change to take effect. After the reboot go back to the AES67
tab and set the multicast prefix address to one that is suitable for your newtork.
Page 40 of 51
Advertisement
Table of Contents
