Setting The Grind Control; Starting Settings - Baratza SETTE 30 Manual

®
Warning: The Sette grinds at a very high speed, be careful not to overfill your portafilter or
bin! If a mound of coffee backs up into the chute it will clog the grinder. Unclogging requires
thorough manual cleaning, and possibly a new internal fuse. For details, see page 8.

SETTING THE GRIND CONTROL

The adjustment ring moves from coarse (31) to fine (1). With the grinder running, turn the knob to the right to move from
coarse to fine. We always recommend the motor be on when making grind adjustments.
Below are the best practices for making accurate and repeatable grind adjustments:
1. Press start/pause button
2. While grinder is running, rotate the grind adjustment assembly until close to desired grinder size
3. Pull bin out and check the particle size.
4. Allow 1-2 seconds more run time, and discard the ground coffee. This small amount of waste is called a
purge, and is crucial in making sure all the ground coffee used is from the same setting.
5. Grind full dose
6. Brew and repeat above steps as needed

STARTING SETTINGS

The settings shown in the table below can be used as a general guideline for starting points*. The actual particle size for a
particular setting will vary depending on many factors including: degree of roast (light vs. dark), freshness, humidity, type
of bean, oil content, etc. With use, you will determine the setting that is right for your taste, brewing style, and your favorite
beans.
Espresso
10
*If you find that your preferred setting is outside of this range, there is no need
to be concerned, grind to your personal taste.
SETTE™ 30 MANUAL
Manual Brew
25
6
May 2019 (v3)