HTP TIMER-DIG Installation Instructions

To ensure safe and enduring performance of this product, you must comply strictly with the instructions enclosed herein. Non-
compliance with instructions or improper handling of the product will void your warranty! This product is designed for use
exclusively with types of fluids or gasses as stated in its documentation. Usage of this product in conditions not specified in the
product documentation or contrary to the instructions hereby provided is considered IMPROPER. The manufacturer will not be held
liable for any damages resulting from improper use of the product.
- Observe valid and generally accepted safety rules when planning. Installing and using this product.
- Take proper measures to prevent unintentional operation of the product or damage to it.
- Do not attempt to disassemble this product or lines in the system while they are under pressure.
- Always turn off the voltage supply before working on the system.
It is important that personnel use safe working practices and observe all regulations and legal requirements for safety when operating
this product. When handling, operating or carrying out maintenance on this product, personnel must employ safe engineering
practices and observe all local health & safety requirements & regulations. International users refer to regulations that prevail within
the country of installation. Most accidents which occur during the operation and maintenance of machinery are the result of failure to
observe basic safety rules or precautions. An accident can often be avoided by recognising a situation that is potentially dangerous.
Improper operation or maintenance of this product could be dangerous and result in an accident causing injury or death. The
manufacturer cannot anticipate every possible circumstance which may represent a potential hazard. The WARNINGS in this manual
cover the most common potential hazards and are therefore not all-inclusive. If the user employs an operating procedure, an item of
equipment or a method of working which is not specifically recommended by the manufacturer he must ensure that the product will
not be damaged or made unsafe and that there is no risk to persons or property.
PLEASE NOTE: YOUR WARRANTY WILL BE INVALIDATED IF THE EQUIPMENT HAS NOT BEEN
INSTALLED OR MAINTAINED IN ACCORDANCE WITH THESE INSTRUCTIONS.
Switch off the voltage supply before Installation or maintenance is
carried out!
TIMER-DIG
SAFETY and PROPER USAGE
ATTENTION
Page 1 General Safety instructions
Page 2 Installation instructions (part 1 of 2)
Page 3 Installation instructions (part 2 of 2)
Page 4 Technical specifications
SAFETY
INDEX
Pag. 1