Subscribe to Our Youtube Channel
Related Manuals for Pangolin FB4-SE
Summary of Contents for Pangolin FB4-SE
- Page 1 FB4 QUICK START GUIDE NITIAL OUTLINE PANGOLIN LASER SYSTEMS PANGOLIN.COM – LASERSHOWPROJECTOR.COM...
-
Page 2: Table Of Contents
Pangolin Laser Systems FB4 quick start guide Table of Contents Device overview ......................2 Getting started ......................4 Operation modes ....................... 5 User interface......................6 Status LEDs ......................... 8 Page 1 of 10... -
Page 3: Device Overview
Pangolin Laser Systems FB4 quick start guide Device overview Figure 1 – FB4-SE Front side OLED display 2. MicroSD card slot 3. RJ-45 ethernet connector 4. Status LEDs 5. UI control knob Page 2 of 10... - Page 4 Pangolin Laser Systems FB4 quick start guide Optional daughterboards Figure 2 – DMX Daughterboard Figure 3 - ILDA Daughterboard Page 3 of 10...
-
Page 5: Getting Started
4. Wait until FB4 has acquired an IP address. The yellow LED should blink once a second. (See the section “Status LEDs” for more information) 5. Start Pangolin Laser Show Designer Quickshow or Beyond on your computer 6. The PC should now connect to FB4... -
Page 6: Operation Modes
FB4 quick start guide Operation modes Beyond/QS In Beyond/QS mode, FB4 connects to Pangolin Quickshow or Beyond software via an ethernet network. Geometric correction is being handled by the control software and native geometric correction on FB4 is turned off to avoid conflicts. -
Page 7: User Interface
Pangolin Laser Systems FB4 quick start guide User interface To modify settings and change operating modes, the control knob can be used in conjunction with the OLED display. Activating the display Press the knob once to activate the display. The bar on the top displays the current operation mode of FB4. The white arrow can be moved between menu items by rotating the knob. - Page 8 Pangolin Laser Systems FB4 quick start guide Changing operation mode In this example, we will demonstrate how to change the operation mode from Beyond to ILDA input. The menu item “ILDA Input” may not be present on your FB4 is there is no “FB4-ILDA”...
-
Page 9: Status Leds
Pangolin Laser Systems FB4 quick start guide Status LEDs Green LED (SD card status) SD card not present SD card present Yellow LED (Network status) Network cable not connected Acquiring IP address IP address acquired but not connected to QS/Beyond... - Page 10 Pangolin Laser Systems FB4 quick start guide Legend LED is permanently off LED is permanently on LED Blinks every second (blinking) LED flashes once a second (flash) LED flashes twice every second (double flash) LED fades from off to on and back to off every second...
- Page 11 If you are not getting any light out, please verify “Scan Guard” is turned off in the user interface. Getting help This document is a quick start guide, not a manual. For full documentation of Pangolin FB4, Pangolin Lasershow Designer Quickshow and Pangolin Beyond please refer to: http://www.pangolin.com/pages/manuals/ If you have any further questions, please contact Pangolin support at: support@pangolin.com...
Need help?
Do you have a question about the FB4-SE and is the answer not in the manual?
Questions and answers