Advertisement
PX2 Series Heavy Duty Pressure Transducers
Figure 4. Pressure Port Type Dimensions (For reference only: mm/[in].)
F1
7/16-20 UNF 1/4 in 45º Flare Female Schrader (SAE J512)
Seal: 45º cone
Mating geometry: SAE J512
Installation torque
: 17 N m [12.5 ft-lb]
1
F3
7/16-20 UNF 37º Flare Male (SAE J514)
Seal
: 37º cone
2,3
Mating Geometry: SAE J514
Installation Torque
: 16 N m [11.8 ft-lb]
1
G2
Seal
: O-ring
2,3
Mating geometry: ISO 1179-1
: 25 N m [18.4 ft-lb]
Installation torque
1
Seal: pipe thread
Mating geometry: ANSI B1.20.1
Installation torque
: 2 to 3 Turns
1
from finger tight
S1
9/16–18 UNF (SAE J1926-3)
Seal
: O-ring
2,3
Mating geometry: SAE J1926-1
Installation torque
: 30 N m [22.1 ft-lb]
2
Notes:
1. Straight thread maximum torque is validated to 150% of installation torque.
2. Seals for pressure port type order codes S1, S2, M1, G1 and G2 are included and assembled to the sensors.
3. O-ring material is nitrile 70 durometer -30 ºC to 125 ºC [-22 ºF to 257 ºF].
"P" = 20,5
[0.81] 15,5
[0.61]
G1/8 (ISO 1179-3)
N1
1/4–18 NPT
22 Hex flat to flat
[0.87]
F2
7/16-20 UNF 45º Flare Male (SAE J513)
Seal: 45º cone
Mating geometry: SAE J513
Installation torque
: 1/4 Turn
1
from finger tight
G1
Seal
: O-ring
2,3
Mating geometry: ISO 1179-1
Installation torque
: 50 N m [38.9 ft-lb]
1
M1
M12 X 1.5 (ISO 6149-3)
Seal
: O-ring
2,3
Mating geometry: ISO 6149-1
: 25 N m [18.4 ft-lb]
Installation torque
1
N2
Seal: pipe thread
Mating geometry: ANSI B1.20.1
Installation torque
: 2 to 3 Turns
1
from finger tight
S2
7/16–20 UNF (SAE J1926-3)
Seal
: O-ring
2,3
Mating geometry: SAE J1926-1
Installation torque
: 18 N m [12.3 ft-lb]
2
ISSUE 8
50052336
"P" = 19,2
[0.75]
12,3
[0.49]
G1/4 ( ISO 1179-3)
1/8–27 NPT
Honeywell Sensing and Control
7
Advertisement
