Other Features; Adjusting The Sound - Sony DHC-EX770MD Operating Instructions Manual

10
Press CD SYNC on the tape deck.
The tape deck stands by for recording
and the CD is in pause for playback. The
CD SYNC indicator lights up and
"PLAY · P {REC}" (for front side)
appears.
11
Press P on the tape deck.
Recording starts.
To stop recording
Press p on the tape deck or the CD player.
Tips
• Pressing SYSTEM POWER on the DHC-MD77/
EX77MD/EX770MD automatically turns on the
TC-TX77/TX770 deck if you connect them to each
other using the audio bus cable.
• If you want to record from the reverse side, press
ª in step 10 so that "ª PLAY P {REC}" (for
reverse side) appears.
• When you record on both sides, be sure to start
from the front side. If you start from the reverse
side, recording stops at the end of the reverse side
even though you select a.
• When you want to reduce the hiss noise in low-
level high-frequency signals, press DOLBY NR
repeatedly to select B or C before step 9. You
cannot switch DOLBY NR during recording.
• If the tape reaches the end of its front side while
dual-sided recording, the fadeout feature works so
that a track is not abruptly cut off at the end of the
tape (Fade Synchro). The track will be recorded
again from the beginning on the reverse side. The
Fade Synchro feature works during one-side
recording, too.
• You cannot perform CD Synchro Recording by
pressing the CD SYNC buttons on both the tape
deck and the MD deck at the same time.
Use the CD Synchro Recording feature for a tape
and record on an MD manually. This method is
recommended since on the MD deck, you can
erase the overlapping track recorded using the
Fade Synchro feature just by specifying its track
number (Erase Function).

Other Features

Adjusting the sound

You can adjust the bass/treble, mute the
sound or listen to the source directly.
DBFB
SOURCE DIRECT
BASS TREBLE
To Do this
Adjust the Turn BASS clockwise to
bass sound increase and counterclockwise
to decrease.
Turn TREBLE clockwise to
Adjust the
increase and counterclockwise
treble sound
to decrease.
Reinforce the Press DBFB* until the LOW or
bass sound HIGH** indicator lights up.
Press the button repeatedly
until the indicator turns off to
cancel.
Mute the sound Press –20dB MUTING to turn
on the indicator. Press the
button again to return to the
original volume.
* DBFB: Dynamic Bass Feedback.
**HIGH is more effective than LOW.
To listen to music without any
audio effects
Press SOURCE DIRECT to turn on the
indicator.
The system outputs the music signals directly
without passing them through any circuit.
Press the button again to cancel.
To listen through the headphones
Connect the headphones to PHONES.
–20dB MUTING
§
EJECT
0 10
PHONES
55 EN