Monoprice SS-6 Quick Install Manual

Monoprice SS-6 Quick Install Manual

Premium 6-channel speaker selector

Advertisement

SS-6 Premium 6-Channel Speaker Selector

INTRODUCTION

The SS-6 Speaker Selector is a resistor-based, impedance matching speaker selector used
for connecting up to six pairs of 4-ohm or 8-ohm speakers, while maintaining a safe
impedance load for your amplifier or receiver. Each pair of speakers can be independently
turned on or off using push buttons on the front panel, with no need for worrying about
amplifier loading.

FEATURES

 Connect and safely control multiple speaker pairs with a single amplifier
 Automatic impedance protection circuitry
 100 watts RMS per channel power capacity
 4.6-ohm minimum amplifier impedance with six 4-ohm speakers selected, 5.3-ohm
minimum with 8-ohm speakers
 Supports 12-16 AWG speaker wire
 Individual zone on/off buttons
 Heavy-duty screw-type connectors
 Isolated left/right circuit grounds provide safe connection for amplifiers with
floating grounds or bridged configurations
 Accurate, noise-free switching
P/N 38158

Quick Install Guide

1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SS-6 and is the answer not in the manual?

Questions and answers

Summary of Contents for Monoprice SS-6

  • Page 1: Quick Install Guide

    Quick Install Guide INTRODUCTION The SS-6 Speaker Selector is a resistor-based, impedance matching speaker selector used for connecting up to six pairs of 4-ohm or 8-ohm speakers, while maintaining a safe impedance load for your amplifier or receiver. Each pair of speakers can be independently turned on or off using push buttons on the front panel, with no need for worrying about amplifier loading.
  • Page 2 INSTALLATION 1. Refer to the manuals for your amplifier and speakers to determine the correct wire gauge to use with the speaker selector. 2. Lay out all wire runs from each speaker location and your amplifier to the selector. 3. Remove the connector blocks from the selector and connect them to the wires, as shown in the image to the right.

Table of Contents