First Operation; Instruction; Initial Charging Procedure; Before Operation - HAKO PowerBoss Phoenix 26 User Manual

First Operation

2 First Operation
2.1

Instruction

Instruction is required before the
first operation. First instruction
into handling of the machine must
be held by a qualified
person sent by your local
PowerBoss dealer. Your
PowerBoss dealer will be
informed upon delivery of the unit
and will contact you to make a
date for instruction.

2.2 Initial Charging Procedure

Before first operation
of the machine, fully
Charge the battery
with an initial charging
procedure and comply
with the operating
instructions of the
charger as well as with
those of the battery
manufacturer.
PowerBoss cannot be
held liable for damages
resulting from the
fact that the initial
charging has not or
insufficiently been done.
10
2.3 Before Operation Of Machine
Perform the following inspections

before operation.

1. Check parking site for signs of
leakage. Hoses, lines and tanks must
be free from any leakage or damage.
2. Install brushes and squeegee, see
maintenance chapter.
3. Install batteries and connect battery
cable, see maintenance chapter.
4. Check battery charge and proceed
to charging of batteries if required.
Generally proceed to initial charging
before first operation of the machine.
5. Empty dirty water Recovery
tank and clean it if required, see
maintenance chapter.
6. Fill clean water tank and add a
cleaning agent according to the
manufacturer's recommendations.
Use only cleaning agents
suitable for automatic
machines (low-foaming
type) and comply with the
instructions for use. Follow
directions for disposal
and warning information
as specified by the
manufacturer.

2.4 Start Machine

Before starting the machine, set
the forward/reverse level to neutral
position. If the lever is not in the
neutral position when machine is
switched on, an error message will
occur. Use the following
procedure reset the machine into
operating mode:
• Disconnect main plug of the
charger from outlet and fasten to
the holder.
• Switch on the machine by turning
the ignition key from position (0) to
position (1).