Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for HAKO Cleanserv VL1-15
Summary of Contents for HAKO Cleanserv VL1-15
-
Page 1: Instruction Manual
Instruction manual Cleanserv VL1-15 / VL1-30 (7142.00 / 7143.00) -
Page 2: Introduction
The operating manual contains all the prescribed by the manufacturer. important information you need to The Cleanserv VL1-15 / VL1-30 may operate, maintain and service the only be operated, serviced and repaired machine. Throughout this operating... -
Page 3: Information On The Warranty
The maintenance. Maintenance work must the damage report to us together with manufacturer is not deemed liable for be performed by authorized Hako the consignment note. any damage resulting from service centers and confirmed in the unauthorized modifications to the “Maintenance Report”... -
Page 4: Table Of Contents
Dry Cleaning Behavior following faults or Cleanserv VL1-15 ..21 accidents ....9 Filter Cartridge (99721900) ... -
Page 5: Safety Information
Safety Information Safety Information Safety and warning symbols All sections related to personal safety, safety of the machine and environmental protection are assigned the following symbols throughout the operating manual: Symbol Damage to ... Definition Read operating manual persons Safety information to prevent hazardous situations or property caused by a failure to follow instructions or prescribed working procedures accurately or at all. -
Page 6: General Information
Faults and defects, particularly in re- tion during work. these documents should be trans- spect of the electrical system, must • The Cleanserv VL1-15 / VL1-30 may ferred to the new owner/operator. be cleared up immediately! only be operated, serviced and re- The transfer should be confirmed! •... - Page 7 • If you are not operating the machine, • The Cleanserv VL1-15 / VL1-30 is not • If smoke, foam or liquid escapes store it out of reach of children. designed for clearing hazardous, from the machine, switch it off imme- •...
-
Page 8: Maintenance Information
Hako service center. the accident prevention regulations. the electrical engineering regula- • Before completing any cleaning and The results of the test must be docu- tions. -
Page 9: Environmental Protection
Safety Information replaced at an authorized Hako serv- Behavior following faults or Disposing of the machine ice center or by an appropriately accidents • Cut off the power cable to render the qualified electrician. • Switch the machine off immediately machine inoperable. -
Page 10: Labels On The Machine
Safety Information Labels on the machine Read the manual Safety Advice The following safety and warning labels are attached to the machine where easily legible. Missing or illegible labels must be replaced immediately. Company logo Rating plate... -
Page 11: Operation
Operation Operation Cleanserv VL1-15 Abb. 1 Abb. 2 1 Vacuum Head 2 Power Switch 3 Locking Device 1 Wet suction Nozzle 4 Tank with Trolley 2 Handle 5 Hose Connector 3 Upholstery Nozzle 4 Brush Nozzle 5 Suction Tube 6 Combination Nozzle... -
Page 12: Cleanserv Vl1-30
Operation Cleanserv VL1-30 Abb. 3 1 Vacuum Head Abb. 4 2 Power Switch 3 Locking Device 4 Hose Connector 1 Wet Suction Nozzle 5 Tank with Trolley 2 Hard Floor Nozzle 3 Carpet Nozzle (Optional) 4 Brush Nozzle 5 Suction Tube 6 Handle 7 Flat Lance 8 Adaptor... -
Page 13: Dry Suction
Operation Wet Suction • Loosen the locking device on the tank and remove the vacuum head from the top. • Remove the filter cartridge from the tank. • Clean the tank, hose and accesso- ries as necessary. • Put the vacuum head back onto the tank with the filter and lock the lock- ing device. -
Page 14: Technical Data
Technical data Technical data Cleanserv VL1-15 VL1-30 Application wet/dry nass/trocken Capacity Supply voltage V/Hz 220-240/50-60 220-240/50-60 Power 1100 1100 Suction mbar 233.4 233,4 Air flow capacity l/sec Bypass motor Total height Width Depth Standart weight Power cable, length Standard accessories NV/mm Ø... -
Page 15: Electrical System Diagram
Technical data Electrical System Diagram Abb. 7... -
Page 16: Maintenance And Service
• Check the float and its guide and carried out by a specially trained opera- clean under suction fan. Check for tor, all other Hako system maintenance free movement and damage. may only be completed by personnel • Clean and rinse the hose and acces- who are correspondingly qualified and soires, remove debris and dirt. -
Page 17: Troubleshooting
Sudden loss of suction during fluid Tank is full Switch off and empty tanks intake * If the main fuse goes out repeatedly have the device checked by an author- ized Hako service. -
Page 18: Optional Accessories
Optional Accessories Optional Accessories Dry Suction with Cleanserv VL1-15 and Cleanserv VL1-30 Recommended Combinations: Filter Insert Filter Cartridge Paper Filter Bag (Included) (Optional) (Optional) Filter Insert Filter Cartridge Paper Filter Bag... -
Page 19: Filter Cartridge (99720700) For Dry Cleaning Cleanserv Vl1-15 / Vl1-30
Clean the surface on the float hous- Dry Cleaning • Remove the vacuum housing from ing if necessary. Cleanserv VL1-15 / VL1-30 the tank. • Pull off the protective seal and glue • Take the existing filter from the tank the seal as shown. - Page 20 Optional Accessories • Install the float and the float hous- ing by slightly turning it clockwise. In addition, if necessary, loosen the three screws slightly • Put the filter cartridge as shown on the float housing and fasten with the supplied cover by turning clock- wise.
-
Page 21: Filter Cartridge (99721400) For Dry Cleaning Cleanserv Vl1-15
Optional Accessories Filter Cartridge (99721400) for Dry Cleaning Cleanserv VL1-15 Inserting the Paper Filter Bag (99721400) Abb. 15 Abb. 14 The paper filter bags can be • Remove the vacuum housing from used in conjunction with the fil- the tank. -
Page 22: Filter Cartridge (99721900) For Dry Cleaning Cleanserv Vl1-30
Optional Accessories Filter Cartridge (99721900) Carpet Nozzle 99720800 for Dry Cleaning for Cleanserv VL1-30 Cleanserv VL1-30 For dry use on carpets or rugs with the Inserting the Paper Filter Bag paper filter bag (99721900) (99721900) Abb. 17 • Remove the vacuum housing from the tank. -
Page 23: Ec-Declaration Of
Hako GmbH For the relevant implementation of the Name of the person authorised for safety and health requirements men- Hako to compile the technical file: Hamburger Straße 209-239 tioned in the Directives, the following D-23843 Bad Oldesloe standard (s) and / or technical specifica- Ludger Lüttel... - Page 24 Spitzentechnik für eine saubere und schönere Umwelt Advanced Technology for a Cleaner, Better Environment · · Hako GmbH Hamburger Str. 209-239 D-23843 Bad Oldesloe · +49 4531 806-0 Fax +49 4531 806-338 ...
Need help?
Do you have a question about the Cleanserv VL1-15 and is the answer not in the manual?
Questions and answers