Sony CMT-DH7BT Operating Instructions Manual page 54

To erase all the pairing registration
information
1
Press FUNCTION +/
to select "BLUETOOTH" (or press
BLUETOOTH 
When the system is connected with a
Bluetooth device (when the Bluetooth
device name or other information
appears in the system display), press
and hold BLUETOOTH OPR
the unit for about 2 seconds to put the
system in Bluetooth standby mode.
2
Press CLEAR
"Delete?" appears.
3
Press ENTER
"Complete!" appears and all the
pairing information is erased.
Note
In order to connect with a Bluetooth device
after performing this operation, you must enter
the passcode again.

GB

repeatedly

on the unit).


.

.
Playing music of a Bluetooth device
You can operate a Bluetooth device by
connecting the system and a Bluetooth
device using AVRCP. If the system is not
connected with a Bluetooth device using
AVRCP, "Not In Use" appears when you
operate the system.
1
Select the Bluetooth function.
Press FUNCTION +/
on
to select "BLUETOOTH" (or press
BLUETOOTH 
2
Establish a connection from the
Bluetooth device.
For details about the operations of
the Bluetooth device, refer to the
operation manual supplied with your
Bluetooth device.
Once the connection is established,
the system display changes as follows:
"Connect"  Name of the Bluetooth
device
3
Start playback.
Press 

on the unit).
Depending on the Bluetooth device,
you may need to start up the AV
software of the Bluetooth device
beforehand.
4
Adjust the volume.
Press VOLUME +/
To check the address of a connected
Bluetooth device
Press DISPLAY
device name appears in the system
display.
The Bluetooth device address appears for
8 seconds.

repeatedly

on the unit).
 (or BLUETOOTH 

.

while the Bluetooth