Sony CMT-BX3R Operating Instructions Manual page 26

 The number of folders has exceeded
999.
 The number of files has exceeded 999.
 Files that are encrypted or protected by
passwords, etc. cannot be played back.
* This system supports FAT16 and FAT32, but
some USB storage media may not support all
of these FAT. For details, see the operation
manual of each USB storage media or
contact the manufacturer.
Tuner
Severe hum or noise, or stations
cannot be received. ("TUNED" or "ST"
flashes on the display.)
 Connect the antenna properly.
 Find a location and an orientation that
provide good reception, and then set
up the antenna again.
 Keep the antennas away from the
speaker cords, the power cord and the
USB cable to avoid picking up noise.
 Connect a commercially available
external antenna.
 Consult your nearest Sony dealer if the
supplied AM antenna has come off the
plastic stand.
 Turn off nearby electrical equipment.
To change the AM tuning interval
The AM tuning interval is factory-preset
to 9 kHz (or 10 kHz, for some areas; this
function is not available on the Russian
model).
Use buttons on the unit to change the
AM tuning interval.
1
Tune in any AM station, and then
turn off the system.
2
While holding down TUNER/BAND

, press /
All the AM preset stations are erased.
To reset the interval to the factory
preset, repeat the procedure.

GB

.
To improve tuner reception
Turn off CD player power by using the
CD power management function. By
default, CD power is turned on.
1
Press FUNCTION
select the CD function, and then turn
off the system.
2
After "STANDBY" stops flashing, press

/
on the unit while holding
down /CANCEL
"CD POWER OFF" appears. With CD
player power turned off, disc access
time is increased. To turn on CD
player power, repeat the procedure
until "CD POWER ON" appears.
To reset the system to factory settings
If the system still does not operate
properly, reset the system to factory
settings.
Use buttons on the unit to reset the
system to its factory default settings.
1
Disconnect and reconnect the power
cord, and then turn on the system.
2

 , /CANCEL
Press

/
at the same time.
All user-configured settings, such as
preset radio stations, timer, and the
clock, are deleted.

repeatedly to

on the unit.

and