Table of Contents
Advertisement
12
#10: Standby Mode
In Standby Mode the device is in deep sleep state allowing for safe
dismounting, transporting and low as possible battery consumption.
The device is shipped in Standby Mode.
Entering the device in Standby Mode will not factory reset the device
nor will result in loosing any data, but calibration and sensor pairing
(after long Standby) is lost.
To enter Standby Mode:
1. use the included key to press and hold the button.
2. Release the button when you see
cyan
LED colour.
3. Quickly click the button to confirm.
4. wait for the LED to stop blinking.
To exit Standby Mode click the button once, the device will enter
first installation procedure.
STAnDBY MODE
Advertisement
Table of Contents
