Specifications - Sony 2-661-374-11(4) Operating Instructions Manual

To save a tape permanently
To prevent a tape from being accidentally recorded
over, break off the tape tab from side A or B as
illustrated.
Break off the
tape tab
If you later want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Before placing a tape in the tape deck
Take up any slack in the tape deck. Otherwise, the tape
may get entangled in the parts of the tape deck and
become damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as playback, stop and fast-winding etc.
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use. Be
sure to clean the tape heads before you start an
important recording or after playing an old tape. Use a
separately sold dry-type or wet-type cleaning tape. For
details, refer to the instructions of the cleaning tape.
Demagnetizing the tape heads
Demagnetize the tape heads and the metal parts that
have contact with the tape after every 20 to 30 hours of
use with a separately sold demagnetizing tape. For
details, refer to the instructions of the demagnetizing
tape.
GB
34

Specifications

Amplifier section
MHC-GNX900 (HCD-GNX900)/
MHC-GNX780 (HCD-GNX780)
The following are measured at
Brazil model:
Mexican model:
DIN power output (rated) 210 + 210 watts
Continuous RMS power output (reference)
MHC-GNX880 (HCD-GNX880)/
MHC-GNX800 (HCD-GNX800)
The following are measured at
Mexican model:
Brazil model:
Other models:
Front/Surround speaker
DIN power output (rated) 180 + 180 watts
Continuous RMS power output (reference)
Subwoofer
Continuous RMS power output (reference)
MHC-GNX700 (HCD-GNX700)
The following are measured at AC 120, 220, 240 V,
50/60 Hz
Front speaker
DIN power output (rated) 170 + 170 watts
Continuous RMS power output (reference)
AC 127 V or 220 V,
50/60 Hz
AC 127 V, 60 Hz
(4 ohms at 1 kHz, DIN)
285 + 285 watts
(4 ohms at 1 kHz,
10% THD)
AC 127 V, 60 Hz
AC 127 V or 220 V,
50/60 Hz
AC 120, 220, 240 V,
50/60 Hz
(6 ohms at 1 kHz, DIN)
225 + 225 watts
(6 ohms at 1 kHz,
10% THD)
200 watts
(8 ohms at 100 Hz,
10% THD)
(6 ohms at 1 kHz, DIN)
220 + 220 watts
(6 ohms at 1 kHz,
10% THD)