Table of Contents
Advertisement
a 1 collar for exhaust ducting 150
mm.
b 1 reducing collar for exhaust
ducting 125 mm.
c 1 non-return flap for fitting into the
exhaust socket on the motor unit
(not needed for recirculation mode)
d 2 covers for the brackets.
e 2 brackets to support the appliance
in the wall unit.
f 1 cover for the charcoal filter slots.
g 1 spacer strip to conceal the gap
between the rear of the appliance
and the wall.
h Conversion kit for recirculation
mode (the conversion kit is not
supplied, but is available as an
optional accessory - see "Technical
data"). The kit contains an exhaust
grille and flexible aluminium hose
with hose clips.
12 screws 4 x 15 mm for securing the
cooker hood into the wall unit.
4 screws M4 x 16 mm for securing the
cooker hood to the brackets and for
securing the spacer strip.
4 screws M4 x 8 mm for securing the
spacer strip.
2 screws 4 x 40 mm,
2 plugs 6 x 36 mm for securing the
cooker hood to the wall (only when
fitting into a 900 mm wide wall unit).
4 screws 4 x 25 mm for securing a
900 mm wide cooker hood.
4 adhesive covers to conceal the
fixing holes which are not required.
1 x T 20 angled key
Installation
37
Advertisement
Table of Contents
