Table of Contents
Advertisement
Installation recommendations
– To achieve optimum vapour
extraction, the cooker hood must be
positioned centrally over the hob, not
to the side.
– The hob should be no wider than the
cooker hood, and if possible, it
should be narrower.
– The installation area must be easily
accessible. The cooker hood should
be easily accessible and easy to
dismantle in the event that service is
required. This should be taken into
consideration when planning the
position of cupboards, shelves,
ceilings or features in the vicinity of
the cooker hood.
Before installation
Before installation, it is important
to read the information given on the
following pages as well as the
"Warning and Safety instructions" at
the beginning of this booklet.
Installation instructions
See enclosed Installation sheet for
instructions on how to install this
appliance.
Setting the deflector plate
When retracted, the deflector plate is
held in place by magnets.
The retaining force of the magnets can
be adjusted. The magnets should be
adjusted so that the deflector plate is
held in place securely on the left and
right hand side and can be lowered
slightly. An angled key is supplied for
adjusting the magnets.
Adjust both sides equally. Turn in
stages by a half turn each time and
check the adjustment by lowering
and raising the deflector plate.
– Turning the adjusting screws
clockwise increases the magnetic
retaining force.
– Turning the adjusting screws anti-
clockwise reduces the magnetic
retaining force.
Installation
35
Advertisement
Table of Contents
