Sony STR-VA555ES Operating Instructions Manual page 75

Switching the COMMAND MODE
You can switch the command mode (AV
SYSTEM1 or AV SYSTEM2) of the remote. If
the command mode of the receiver and the
remote is different, you cannot use the remote
to operate the receiver.
1
Press SET UP.
The set up list appears.
p
2
Move the easy scroll key to select
"COMMAND MODE", then press the key
to enter the selection.
The COMMAND MODE list appears.
p
3
Move the easy scroll key to select "AV
SYSTEM1" or "AV SYSTEM2", then
press the key to enter the selection.
Tip
When the remote is turned on, the COMMAND
MODE appears in the first line of the display.
Note
"3RD ROOM" is not available for this receiver.
Clearing all the contents of remote's
memory
Be sure to turn on the receiver and point
the remote towards the receiver when
performing the following procedure.
1
Press SET UP.
The set up list appears.
p
2
Move the easy scroll key to select "ALL
CLEAR", then press the key to enter
the selection.
The ALL CLEAR list appears.
p
3
Move the easy scroll key to select
"Yes", then press the key to enter the
selection.
"CLEAR OK?!" appears.
p
4
Move the easy scroll key to select
"Yes" again, then press the key.
All the contents of the remote's memory (i.e.,
all the programmed data) are cleared.
75