Sony STR-DV10 Operating Instructions Manual page 50

Remote control
The remote does not function.
• Point the remote at the remote sensor
receiver.
• Remove any obstacles in the path between the
remote and the receiver.
• Replace all the batteries in the remote with new
ones, if they are weak.
• Make sure you select the correct input on the
remote.
• You need to assign a function to the VIDEO 3
button before you can use the button to control
your audio/video equipment. For details, refer
"Changing the factory setting of an input button"
on page 46.
• To activate the buttons with orange printing, press
TV and the button you want simultaneously.
• Before you use the V/v/B/b button for receiver
operation, press MAIN MENU. To operate other
components, press TOP MENU/GUIDE or AV
MENU after pressing the function button.
Error messages
If there is a malfunction, the display shows a
message. You can check the condition of the
receiver by the message. Refer to the following
table to solve the problem.
DEC. EROR
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when "DEC. XXXX"
in the CUSTOMIZE menu is set to "DEC. PCM".
Set to "DEC. AUTO".
PROTECT
Irregular current is output from the speakers. The
receiver will automatically turn off after a few
seconds. Check the speaker connection and turn on
the power again. If this problem persists, consult
your nearest Sony dealer.
US
50
If you are unable to remedy the
problem using the
troubleshooting guide
on the
Clearing the receiver's memory may remedy the
problem (page 17). However, note that all
memorized settings will be reset to their factory
settings and you will have to readjust all settings
on the receiver.
If the problem persist
Consult your nearest Sony dealer.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields
See
page 17
page 37