Preventing Interference Between Multiple Remotes (Str-De905G Only); How To Use The Remote: Str-De905G - Sony STR-DE805G Operating Instructions Manual

Preventing Interference
Between Multiple Remotes
(STR-DE905G only)
If you use two or more receivers at the same time,
interference may occur between the RF signals, causing
the units to operate erratically. You can prevent this by
giving all units a unique security number which
distinguishes the signal of each unit from the others.
Follow the procedure below to assign a security
number to each unit.
1
Turn off the power to the unit.
2
Turn on the unit again while simultaneously
holding down the PHONO, CD, and TUNER
buttons on the front panel. "SECURITY No."
appears in the display. Enter a number from 0 to
15 by pressing PHONO, CD or TUNER on the
front panel. Make sure that the number is
different from the security code of the other units.
3
After a few seconds, "SECURITY OK!" appears,
indicating that the code has been recorded.
4
Enter the same security number into the remote.
To do this, open the battery compartment and
remove the batteries. You will see a set of yellow
switches as shown below.
Use the tip of a pen or some other pointed object
to flip up the appropriate switches for each digit
of the security number (refer to the chart on the
following page). Note that all switches are down
for zero, and all switches are up for fifteen.
5
Reinsert the batteries and place the remote on a
flat surface for about 10 seconds.
Preparing and Using the Remote
SECURITY
NO.
0
1
2
3
4
5
6
7
How to Use the Remote:
STR-DE905G
The supplied remote lets you perform almost all of the
receiver operations. Operation is simple, just move the
remote in the direction you want to move the pointer
(hand shaped icon) on the on-screen display. Position
the pointer so that the finger tip is positioned on one of
the on-screen items, then press and quickly release the
button on the remote to "click" the item.
Yellow
switches
Blank
area
Click button
To turn on the receiver
Press the click button on the remote once or twice to turn on
the unit.
Remote SECURITY
commander NO.
8
1 2 3 4
9
1 2 3 4
10
1 2 3 4
11
1 2 3 4
12
1 2 3 4
13
1 2 3 4
14
1 2 3 4
15
1 2 3 4
FUNCTION
Pointer
S
O
U
N
D
SUB
0 ( ) p P
Remote
commander
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
ALL
OFF
VOL
+
–
USER
= +
15 EN
(continued)