Full Auto Playback; Auto Rental Mode - Sharp VC-A210X Operation Manual

M
Playback
Quick Start with Full Loading
iVlechanism
I/our
VCR
has a standby function (Full Loading
>dechanism) to allow immediate recording and
olayback.
qfter pressing the REC or PLAY/X2 button, it
:akes about 2 seconds until recording or
Jlayback is engaged when in the standby mode.
Auto Rental Mode
This function only works when AUTO RENTAL
node on the MODE selection screen is set to
3N.) The convenient auto rental mode lets you
enjoy playback with ease. When you insert a
cassette with the erasure protection tab removed
rental videos, etc.), your VCR automatically turns
3n the power, winds the tape forward to find the
recorded section, and plays back the tape. When
the tape reaches the end of recorded section, the
VCR automatically rewinds the tape, ejects it and
turns off the power.
l
If there is more than a 15 second unrecorded section
between recorded sections, the tape will automatically stop
and rewind. To watch the next recorded section, press the
STOP button, fast forward to that section and play the tape.
l
If the erasure protection hole is covered, press the PLAY/x2
button after the power turns on automatically. (Auto Rental
Mode does not work.)
l
The AUTO REPEAT mode has priority over the AUTO RENTAL
mode. If the AUTO REPEAT mode is set to ON and the video
cassette reaches its end, the VCR will rewind the tape and
play it back again without ejecting the tape or turning off the
power.
Blue Back
Set the BLUE BACK mode to AUTO on the
MODE-selection screen. (See Mode Selection on
page 14.) This function eliminates monitor noise
and mutes sound during playback of unrecorded
portions of a tape, and when receiving a non-
broadcasting channel. A blue screen will also
appear if the VCR is set to the Auxiliary input
(LINE IN) mode but no video signal is fed to the
VCR. (The BLUE BACK mode is set to AUTO at
the factory.)
l
Blue Back does not function during still picture and
video search.
l
Blue Back may not function properly if the broadcast
signal is too strong or too weak.
l
Blue Back cannot be recorded.
l
If the antenna signal is weak while recording a TV
programme, or if the input signal is weak while tape
dubbing, the monitor screen may turn
blue
since the
unit may not recognize whether or not a proper signal
is being received. In this event, set the BLUE BACK
mode to OFF.
Full Auto Playback
(This function only works when AUTO RENTAL
mode on the MODE selection screen is set to
OFF.) Full Auto Playback lets you enjoy playback
with ease. When you insert a cassette with the
erasure protection tab removed, your VCR
automatically turns on the power and plays back
the tape. When the tape reaches its end, the VCR
automatically rewinds the tape, ejects it and turns
off the power.
l
If the erasure protection hole is covered, press the
PLAY/x2 button after the power turns on
automatically.
17