Automatic Tuning; Preset Tuning - Sony STR-DE525 Operating Instructions Manual

Automatic Tuning

For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 30.
1
Press TUNER to light the button up.
The last received station is tuned in.
2
Press FM/AM to select the FM or AM band.
3
Press TUNING + or TUNING –.
Press the + button to scan from low to high; press the –
button to scan from high to low.
When the receiver reaches either end of the
band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is
received.
4
To continue scanning, press TUNING + or TUNING –
again.

Preset Tuning

For details on the buttons used in this section, see "Brief
descriptions of buttons used to receive broadcasts" on
page 30.
Before you can tune in a preset station, first do the
procedure "Presetting radio stations" below.
Presetting radio stations
1
Press TUNER to light the button up.
The last received station is tuned in.
2
Tune in the station that you want to preset using
Direct Tuning (page 30)‚ or Automatic Tuning (this
page).
3
Press MEMORY.
"MEMORY" appears in the display for a few seconds.
Do Steps 4 and 5 before "MEMORY" goes out.
4
Press SHIFT to select a memory page (A, B or C).
Each time you press SHIFT, the letter "A," "B" or "C"
appears in the display.
5
Select a preset number by pressing it (0 to 9).
If "MEMORY" goes out before you press the preset
number, start again from Step 3.
6
Repeat Steps 2 to 5 to preset another station.
To change a preset number to another station
Do Steps 1 to 5 to preset the new station to the number.
Note
If the AC power cord is disconnected for about one week, all the
preset stations will be cleared from the receiver's memory, and
you will have to preset the stations again.
31