Using The Sleep Timer; Selecting The Speaker System - Sony STR-DB1080 Operating Instructions Manual

Using the Sleep Timer

You can set the receiver to turn off
automatically at a specified time by using the
remote.
For details, refer to the operating instructions
supplied with the remote.
Models of area code U, CA
Use the supplied remote RM-PG411.
1
Press ALT.
2
Press SLEEP while the power is on.
Each time you select SLEEP, the display
changes cyclically as follows:
2:00:00 t 1:30:00 t 1:00:00 t 0:30:00 t
OFF
While using Sleep Timer, "SLEEP" lights up in
the display.
Models of other area codes
Use the supplied remote RM-LP211.
Select SLEEP from the RECEIVER menu
repeatedly while the power is on.
Each time you select SLEEP, the display
changes cyclically as follows:
2:00:00 t 1:30:00 t 1:00:00 t 0:30:00 t
OFF
While using Sleep Timer, "SLEEP" lights up in
the display.
Models of area code SP, KR, E only
You can also use the SLEEP button on the
receiver.
Tip
To check the remaining time before the receiver turns
off, touch or press SLEEP. The remaining time
appears in the display.
Selecting the speaker
system
(Models of area code U, CA, CEL,
CEK, SP, KR only)
Set the SPEAKERS switch according to the
front speakers you want to drive.
Set to To select
A The speakers connected to the FRONT
SPEAKERS A terminals.
B The speakers connected to the FRONT
SPEAKERS B terminals.
A+B* The speakers connected to both the
FRONT SPEAKERS A and B
terminals (parallel connection).
The sound field is automatically set to
2CH STEREO.
OFF No speaker output.
* Be sure to connect front speakers with a nominal
impedance of 8 ohms or higher if you want to select
both sets of front speakers (A+B). In this case, set
the IMPEDANCE SELECTOR to "4 ".
Models of area code E only
Use the SPEAKERS switch to turn the speaker
output OFF or ON.
GB
57