Advertisement
Push a button to select the proper heat
Fabric Care
Selections
Cottons
High Heat
Perm Press
Medium Heat
Low Heat
Fluff
No Heat
(Operates only with Automatic,
Perm Press & Knits Cycles. )
Turn to ON if desired. To minimize
wrinkles set in the clothes, the Extra
Care cycle provides approximately
15 minutes of no-heat tumbling
after the clothes are dry.
Use End-of-Cycle Signal. Signal
will sound at five-minute intervals
to remind you to remove the clothes.
End-of-Cycle Signal
(Operates with any cycle. )
The Signal control can be set
anywhere between OFF and
LOUD, depending on desired
sound level. The signal will sound
just before the end of the cycle to
remind you to remove the clothes.
To stop signal while sounding, turn
Signal control to OFF or advance
Cycle Selector to OFF.
The Signal should always be used
when drying Polyester Knits or
Permanent Press items which
should be removed as soon as the
dryer stops to help prevent setting
of wrinkles.
The signal should also be used with
the Extra Care Cycle.
for your load.
Should be used with cycles indicated .
Automatic,
Perm Press and
Automatic
Regular Cycle
Knits Cycles
desired. (See below. )
cycle setting. The selector may be
turned in either direction.
to start dryer. (Opening the door
during operation stops the dryer. To
the START button. )
Polyester Knits &
Permanent Press
drying tips
DO NOT OVERLOAD—
Garments being dried or
. REMOVE CLOTHES
wrinkling, remove from the dryer
promptly at the end of the drying
cycles.
. PLACE ON HANGERS—
Permanent Press and Polyester
Knit garments look best if placed
on hangers after drying.
What is the difference
between ~med &
Automatic drying?
Timed Drying
Timed
When using the TIMED CYCLES,
Cycles
you select the number of minutes
you wish the dryer to run and it
turns off at the end of this time
period.
Automatic Drying
When using the Automatic Cycles,
the El('c'[rotli( St'n.\t)r Conlrol
moisture in the tumbling clothes,
determines when they are dried to
your pre-selected setting, and
terminates the cycle automatically.
Refer to the CONTROLS SETTING
GUIDE for recommended settings.
The Cycle Selector will not advance
until clothes have reached a certain
degree of dryness.
Dryness selections guide for
the automatic cycles
5
Set
to Middle Position
s
,1,
e
For most normal loads.
Set toward MORE DRY
For loads that include heavy-
weight
fabrics.
If you desire to remove more
moisture.
Set toward LESS DRY
For lightweight fabric loads
If you desire to remove less
moisture.
For very small loads.
Advertisement
