Cool Mode; Eco Mode - GE ENERGY STAR AEC18 Series Owner's Manual & Installation Instructions

Using the Air Conditioner
Control Display On and Off
To reduce brightness during sleeping hours, this
air conditioner control display has an automatic
off feature where the control display will turn
off completely after 5 minutes of inactivity. To
illuminate the control interface, press any button on
the control display or remote control. The control
display will illuminate all previously illuminated
LED's. The control interface will now respond to
any prescribed button press after it is illuminated.
Press and hold the FAN+MODE buttons
simultaneously to toggle this feature ON or OFF. The
LED's will now stay ON anytime the unit is ON.
Do Not Operate in Freezing Outdoor Conditions
This cool-only air conditioner was not designed for freezing outdoor conditions. It must not be used when the outdoor
temperature is below freezing (32°F).
Remote Control
To ensure proper operation, aim the remote control at the
signal receiver on the air conditioner.
the remote control that could block the signal.
The remote control signal has a range of up to 20 feet.

Cool Mode

Decrease - pads to set the desired temperature between
64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room
temperature. The compressor will cycle on and off
to keep the room at the set level of comfort. Set the
thermostat at a lower number and the indoor air will
become cooler. Set the thermostat at a higher number
and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on
while set to a Cool setting or if turned from a fan setting
to a Cool
the compressor to start and cooling to begin.

ECO Mode

This mode optimizes the cooling power of your air
conditioner, thereby saving you energy. Once the set
point temperature has been reached, the fan will cycle
off to save energy. The fan will cycle back on periodically
to insure all cooling capacity in the system is used. This
mode is the default mode for the unit. Each time the
unit is powered off, it will restart in ECO mode ON. This
includes Delay timer mode. The first time the unit is
turned on, the settings will be 70° and Low fan. You can
adjust the fan speed and temperature to your personal
comfort.
49-5000090
Control sound on/off
This air conditioner will make a beep when the buttons
on the control are pushed or if the unit receives a
command from the mobile app or remote control. To
silence these beeps, simultaneously press the FAN
and "-" buttons for 3 seconds. Press these buttons
again to toggle the sound back on.
indicated on the remote control.
surfaces.
Cooling Descriptions
For Normal Cooling—Select the Cool mode and
High or Med fan with a middle set temperature.
For Maximum Cooling—Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling—Select the
Cool mode and Low fan with a middle set temperature.
ON—The fan will cycle on and off with the compressor.
This may result in wider variations of room temperature
and humidity. NOTE: the fan may continue to run
for a short time or may pulse intermittently after the
compressor cycles off to sample the room air.
OFF—The fan runs all the time, while the compressor
cycles on and off.
5