GE ENERGY STAR AEC18 Series Owner's Manual & Installation Instructions page 12

Installation Instructions
5. PREPARE THE WINDOW AND
INSTALL THE CASE
A.
Cut the window sash seal to the proper length.
Peel off the backing and attach the seal to the
underside of the window sash.
B.
Open the window and mark the center of the
window sill.
C.
Carefully slide the case into the window and
center the case. Lower the window behind the
top mounting rail. Pull the bottom of the case
forward so that the bottom mounting rail is tight
against the back of the window stool. Mount the
case to the window sill using 2 type B screws.
Drill pilot holes, if necessary.
Stool
D.
Assemble the V-support and V-support bracket
with Type F nut and bolt.
Left
Sill angle
bracket
V-support
Type F bolt
and nut
12
2 type B screws
Type E bolt
and nut
Right
5. PREPARE THE WINDOW AND
INSTALL THE CASE (continues)
E
. Position the V-supports
on the case bottom so
that they will be near the
outside wall. Attach a
V-support to each side of the
bottom of the case with Type
E bolts, 2 for each support.
F.
Adjust sill angle brackets to rest on sill.
G
.
to the vertical window sashes. Drill pilot holes
attach the top corners with 2 type C screws.
Type C
screw
V-support
Sill
Bracket
and
Type C
screw
49-5000090