Table of Contents
Advertisement
Section 3.4: Attach to the Take Up Mandrel
Before you begin this section you'll want to have cardboard cores that are no wider than the
width of the liner of each label column after it has been slit. It is usually acceptable to use cores
that are smaller than the liner width. However, this ultimately depends on what type of applicator
will be used to apply your labels, if any. Check the requirements of that system to be sure.
1. Cut the labels and the edge waste as shown. See section 3.3 for instructions on getting
to this point.
2. Remove the labels that have wrapped around the take-up mandrel.
3. Remove the take-up mandrel. Place three cores with a width equal to or less than the
width of the liner for each Column. Center the cores on each of the columns.
19
Advertisement
Table of Contents
