Table of Contents
Advertisement
4. Overview and Use
The S105 must be placed in a frost free
room only.
To ease the operation leave as much free space
around the unit as possible.
5. Installation
For safety reasons it is important to
read all of the enclosed information be-
fore installation of this equipment. In ad-
dition, the legislation in force at the time
of purchase must always be considered
in connection with the installation and
mounting of this equipment, no matter
the contents of this manual.If there are
matters of dispute please contact your
dealer.
5.1. Directions for Mounting
It is recommended to mount the S105 in an appropri-
ate height, however, max. 130 cm above the floor on
a moisture repellent wall construction. The unit must
be placed so that the water inlet hose can reach the
connecting point.
Bore
0,6
3,2
0,7
4,4
0,8
6,0
0,9
7,0
1,1
8,9
1,3
10,2
1,5
10,9
• Do not use TOPAX 58
• During use of Topactive DES it is extremely important that the injector is
rinsed through with clean water after use.
Secure the S105 and the wall hose storage with the
enclosed screws and rawlplugs.
5.2. Water Connection
It must be expected that the foam quality and the rins-
ing effect wiill be reduced if the requirements to the
water wupply are not met.
Taps, mixing batteries etc. may have a limiting ef-
fect on the water quantity. If one of these are placed
before the unit and the water quantity is not sufficient,
it is recommended to replace it with a ball valve. The
replacement should be carried out by an authoried
plumber.
5.2.1.
Recommended products
3,2
3,2
3,2
4,4
4,4
4,4
6,0
6,0
6,0
7,0
7,0
7,0
8,9
8,9
8,9
10,2
10,2
10,2
10,9
10,9
10,9
Hose holder and can holder should be
placed so that the can is under the level
of the unit.
A closing valve must be mounted
directly before the unit.
Supply of Detergent
2,4
2,4
3,4
3,4
4,5
4,5
5,4
5,4
7,6
7,6
8,8
8,8
9,7
9,7
2,4
2,4
3,4
3,4
4,5
4,5
5,4
5,4
7,6
7,6
8,8
8,8
9,7
9,7
13
Advertisement
Table of Contents
