Advertisement
Leds
RAISE LED
LOWER LED
REV PWR LED
OK LED
COM1 TX/RX LEDS
ALARM LED
V/RED LED
MANUAL LED
LOCAL LED
External connection locations
Top View
Control Power
Backup Input
Fiber Optic V-Pin
Connector (optional)
T X
RJ-45 Ethernet over
Fiber Optic
Copper (optional)
ST Connector
2
Ethernet over Fiber
Optic (optional)
BlueTooth
RS-485
RS-232 DE9S
Front
Out of Band Low Voltage
Out of Band High Voltage
Indicates reverse power flow
Illuminates to indicate the micro controller is functioning properly and is extin-
guished when a Motor Seal-in Failure Block is in effect
Indicates when control is transmitting and/or receiving data
Indicates any of the programmable alarms are activated
Indicates voltage reduction has been invoked
- Continuous illumination and one periodic flash indicates Level 1 Voltage
Reduction
- Continuous illumination and two periodic flashes indicates Level 2 Voltage
Reduction
- Continuous illumination and three periodic flashes indicates Level 3 Voltage
Reduction
Indicates automatic control is disabled and in manual mode
Indicates control is switched into Local mode, cannot command control to raise or
lower via SCADA
T X
In-Line, 6-Pin Connector
for the M-2025B, C or D
Current Loop Module
24-Pin Blue Connector for
TCC300 Adapter Panels or
Direct Connection
Bottom View
Front
Source Voltage Input
One Aux Output
Three Aux Inputs
Advertisement
