Setting The Clock - Sony CMT-HX9DAB Operating Instructions Manual

To run the DAB Automatic Scan
When you turn on the system for the first
time after you purchase the system, DAB
Automatic Scan starts automatically and
creates a list of available services. If you
want to run the DAB Automatic Scan
again, perform the procedure below.
1
Press DAB AUTO SCAN
unit.
"Auto Scan? Push ENTER" appears.
2
Press ENTER
Scanning begins. "Auto Scan" appears.
Depending on the DAB services
available in your area, scanning may
take a few minutes.
When scanning is complete, a list of
available services is created.
Notes
 If your country or region does not support
DAB broadcast, "No Service" appears.
 Do not press any button on the unit or
the remote during DAB Automatic Scan.
Scanning is interrupted and service list may
not be created properly. In this case, run the
DAB Automatic Scan again.
 If you move to another area, repeat this
procedure to store the stations for your new
area.
 This procedure clears all previously stored
presets.
 Before unplugging the DAB antenna, make
sure the system is turned off to preserve your
own DAB settings.
 This tuner does not support data services.
1
GB

on the

.

Setting the clock

Use buttons on the remote to set the
clock.
1
Press / 
to turn on the
system.
2
Press CLOCK/TIMER SET
If the current mode appears on
the display, press /
repeatedly to select "CLOCK SET?"
and then press ENTER
3
Press /
to set the hour, and then press

ENTER .
4
Use the same procedure to set
the minutes.
The clock settings are lost when you
disconnect the power cord or if a
power failure occurs.
To display the clock when the system
is off

Press DISPLAY . The clock is displayed
for about 8 seconds.

.


.

repeatedly