HP vc4825T Disassembly Instructions page 2

Tool Description
Description #1 Phillips screwdriver
Description #2 Dikes
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. To remove the secure USB compartment cover (see Figure 1):
a. On rear of the thin client, remove the screw that secures the compartment cover to the unit (1).
b. Push the compartment cover about 0.6 cm (1/4 inch) toward the front of the unit (2), and then lift it off the unit (3).
2. To remove the access panel (see Figure 2):
a. Remove the secure compartment cover (1).
b. Slide the access panel about 3 mm (1/8 inch) toward the top of the unit (2), and then lift the access panel up and off
the unit (3).
3. To remove the metal side cover (see Figure 3):
a. Remove the four screws that secure the metal side cover to the chassis (1).
b. Lift the metal side cover, rear side first, off the unit (2).
4. To remove the battery, gently push the metal guard that extends above one edge of the battery very slightly toward the
rear of the unit, and then lift the battery out (1) (see Figure 4).
5. To remove the system board:
a. Remove the five screws that secure the system board to the thin client chassis (see Figure 5).
b. Unplug the speaker cable from the system board.
c. Pull the system board and rear connector panel out of the rear of the unit. The rear connector panel and system
board will remain together.
6. Cut the two capacitors from the system board as shown in Figure 5.
EL-MF877-00
Template Revision A
Tool Size (if
applicable)
Page 2