Safety Information - Chambers MRS330 Important Instructions Manual

Problem
Check that the appliance is no a
Check the spacing around the appliance and ensure it is not
touching other
Bubbling and gurgling
refrigerant fluid flows through the pipes within the
normal
Water flowing sound: This is the normal sound of water flowing
into the drain trough during the defrosting process.
Unusual noise
If the appliance is operating noisily (compressor noise): This is
normal. This noise indicates that the compressor is operating
normally. As the compressor is being
more noisily for a brief
Contraction and expansion of the inside walls may cause popping
and cracking
If the door has just been
The fridge door will not open
allow the air pressure to equalize before trying
The temperature is set too
The compressor
The door is
The door gaskets are
runs continuously
Large quantities of food have been added to the
The room temperature is hotter than usual.
The exterior walls can be warmer than room
The external fridge
normal while the compressor works to transfer heat from inside the
fridge cabinet.
surface is warm .
Solution
flat, level surface and is
items.
sound: This noise is emitted as the
system.
energized, it might run a bit
period.
noises.
opened, leave it for a few minutes to
again.
cold: select a lower (warmer)
open, or something is obstructing proper door
worn, dirty or damaged.
fridge.
temperature.
WARNING!
stable.
-This appliance is heavy. Care should be taken when moving it. To avoid back or other
consider a two person lift or mechanical aid when installing it.
Failure to do so can result in back or other injury.
-Avoid prolonged exposure of the appliance to direct sunlight.
This is
-This appliance is intended to be used in household only.
WARNING!
-Any electrical components
service agent or qualified service personnel.
-DO NOT USE AN EXTENSION CORD. Use an exclusive wall outlet. Do not connect your
refrigerator to extension cords or in an outlet used by any other appliance.
-Make sure that the power plug is not squashed or damaged by the back of the appliance. A
squashed or damaged power plug may overheat and cause a fire.

Safety information

-Adequate air circulation should be around the
achieve sufficient
-Make sure that the mains plug is accessible after the installation of the
setting.
closure.
This is
Safety information
-Do not put hot food in the appliance.
-Store pre-packed food in accordance with the food manufactures instructions.
-WARNING! Do not use mechanical devices or other means to accelerate the defrosting process.
Never use a sharp or metal instrument to remove frost or
scraper if necessary.
-Appliance storage recommendations should be strictly adhered to. Refer to relevant instructions.
-If the refrigerator is
restarting the unit. If you attempt to
(plug, power cord, compressor etc.) must be replaced by a certified
appliance, lacking this leads to overheating. To
ventilation, follow the instructions relevant to installation.
Before first use and before connecting the unit to the power
source, let it stand upright for approximately 24 hours. This will
reduce the possibility of a malfunction in the cooling system from
handing during transportation.
clean
unplugged, turned off or has lost power,
restart before this time
injury,
appliance.
the appliance. Use a plastic
you must wait 3 to 5 minutes before
delay, the refrigerator will not start.