Wiring Harness Layout - Sony GDM-20SHT Service Manual

GDM-20SHT
2-9. WIRING HARNESS LAYOUT
(1) Left Side
(2) Right Side
o
block assy Power block assy
• REMOVAL OF ANODE-CAP
NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after
removing the anode.
• REMOVING PROCEDURES
CD
Turn up one side of the rubber cap in
the direction indicated by the arrow
0.
• HOW TO HANDLE AN ANODE-CAP
®
Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow®.
~
Don't hurt the surface of anode-caps with shartp shaped material!
Don't press the rubber hardly not to hurt inside of anode-capsl
A material fitting called as shatter-hook terminal is built in the
rubber.
®
Don't turn the foot of rubber over hardly!
The shatter-hook terminal will stick out or hurt the rubber.
- 11 -
Anode Button
®
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling up it in the
direction of the arrow @'