Pioneer DJM-900NXS2 Quick Start Manual page 5

DVS Control
To use the Pioneer DJM-900NXS2 mixer with DVS control and Serato DJ,
you will first need to own a Serato DJ licence and a DVS Expansion Pack
licence (these two products have been bundled together as the Club Kit).
Click here to purchase the Club Kit
Once you have purchased and activated the Club Kit (or individual licences
separately) follow the steps below to get DVS control working with your
Pioneer DJM-900NXS2 mixer.
Install Drivers
Connect your mixer and open the latest version of Serato DJ. You should
see an 'INSTALL DRIVER' dialogue box appear in the right hand side-
panel. Click 'INSTALL DRIVER' and follow the installer prompts. If you don't
have the supported hardware with you right now you can still download the
driver from the hardware manufacturers website.
Select Input source
Once your turntables or CDJs are connected to the mixer, open the SETUP
screen and click the AUDIO tab. Click the SETUP INPUTS button to open
the Pioneer device driver panel. Select the input source you have connected
under the MIXER OUTPUT tab. Depending on what kind of input you
have connected (Turntables/CDJs) you will need to make sure this is set
accordingly for each channel.
NOTE: If you do not set the mixer's input accordingly, DVS control will not
work. Please make sure you have set the correct inputs and outputs in the
SETUP INPUTS driver panel.
Select Primary Decks
Also in the AUDIO tab of the SETUP screen, you will need to select your
Primary Decks.
Choosing Channel 1 and 2, will allow you to have a traditional 1-2-3-4
channel configuration. Choosing Channel 2 and 3 will allow you to have
a 3-1-2-4 configuration (from left to right across the mixer).
Select which deck configuration you are using with the mixer and change
if necessary. If you notice you are getting signal from your control tone but
on the wrong deck, you might need to double-check your Primary Decks in
the SETUP screen or the physical inputs on the back of the mixer.
You are now set up to use your mixer with Serato DJ and DVS control
using the REL or ABS control modes. See the Serato DJ manual for more
information on Control Modes.