Mounting The Splash Guard Cap - ABB HART Industrial IT enabled TZIDC Operating Instructions Manual

Electro-pneumatic positioner for 4...20 ma two-wire technology

Table of Contents

The connections have to be arranged, according to their marks, in the following way:

Mark

OUT1

OUT2

3.2.3 Mounting the splash guard cap

NOTICE

Screw the splash guard cap delivered with your positioner into the appropriate hole in the

bottom plate of the case, as seen in the illustration below. Do not use a screw driver for

this purpose!

Fig. 16

Mounting the splash guard cap

41/18-79 EN

Connection piping

Air supply, pressure 1.4...6 bar (20...90 psi)

Output pressure, to actuator

Output pressure, to actuator (second output, for double-acting

actuators)

Protection class IP 65 / NEMA 4 X is achieved only when the splash guard

cap is in place. Do not use the positioner without the cap.

Electro-pneumatic positioner TZIDC

Table of Contents