Advertisement
By pressing the A-pusher, you will stop the measurement. Finally,
pressing the B-pusher will reset the center stop-second hand back
to its zero position.
RESET CHRONOGRAPH HANDS TO
Your chronograph hands may be set at a different position than
zero. Often this happens when a watch crown has been kept at po-
sition 1 or 2 while operating the A or B pushers. This can be easily
corrected.
RESET THE CENTER STOP-SECOND HAND TO
Pull the crown out to position 2. This will deactivate your watch.
Now, press both A and B pushers simultaneously and keep them
pressed for 2 seconds. When you notice that the center stop-se-
cond hand makes a full rotation, the watch is ready for recalibration.
You can now release both pushers.
Press the A-pusher to reset the start position of the center stop-se-
cond hand. This can be done in two ways: 1) repeatedly pressing
the A-pusher will allow you to set the center stop-second hand with
exact strokes of a second, or 2) keeping the A-pusher pressed will
enable you to set the center stop-second hand to the zero position
fluidly.
Once set, push the crown to its normal position 0 and test your
chronograph. The center stop-second will now start & stop from
the zero position.
ZERO POSITION
ZERO POSITION
Advertisement
