1. Manuals
  2. Brands
  3. Snap Appliance Manuals
  4. Storage
  5. Snap Disk 10
  6. Quick start manual

Snap Appliance Snap Disk 10 Quick Start Manual

Hide thumbs

Advertisement

Table of Contents

Quick Start Guide and User CD
Kurzanleitung und Benutzer-CD
Guía de iniciación rápida y CD del usuario
Guide de mise en route rapide et CD de l'utilisateur

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Snap Disk 10 and is the answer not in the manual?

Questions and answers

Related Manuals for Snap Appliance Snap Disk 10

Summary of Contents for Snap Appliance Snap Disk 10

  • Page 1 Quick Start Guide and User CD Kurzanleitung und Benutzer-CD Guía de iniciación rápida y CD del usuario Guide de mise en route rapide et CD de l’utilisateur...

  • Page 2: About This Guide

    About This Guide The Snap Disk 10 storage subsystem is a 1U expansion array with four ATA disk drives and a single Serial ATA ® connector. This Quick Start Guide shows you how to quickly install and connect a Snap Disk 10 to a Snap Server 4500.

  • Page 3: Hardware Features

    Disk drive status lights Front bezel Serial ATA cable Stacking clips (four) Power cables Quick Start Guide Serial ATA card* Serial ATA connector Rack mount brackets (ears) *The Serial ATA card is ordered and shipped separately from the Snap Disk 10...
  • Page 4 To secure the cover, tighten the screw at the rear of the server. Do not operate the Snap Server without the top cover in place. DO NOT restore power at this time. Proceed to the next sections to install the Snap Server and expansion array(s) in a rack and connect the cables to the Snap Disk 10.

  • Page 5: Rack Installation

    Snap Server 4500. The Snap Disk 10 ships with two L-shaped rack mount brackets. You can attach them in one of two ways: (1) to the front of the server for mounting to the front posts of a four-post rack; or (2) to the middle or front of the server for mounting to both posts of a Telco rack.
  • Page 6 Serial ATA connector. Connect the other end of the cable to the Serial ATA connector at the rear of the Snap Disk 10, and then tighten the locking screws on either side of the Serial ATA connector.
  • Page 7 EXTN1 or EXTN2 showing their external location. When accessed from a client, the Snap Disk 10 appears as a new share on the Snap Server it is attached to. By default, it is configured as a RAID 5 with a single volume and share, with full access to the share by all users across all protocols.

Table of Contents