Denon DRA-800H Owner's Manual page 139

Contents Connections
Power savings are always active,
On:
regardless of volume or input signal.
Gives you the best balance between
power savings and maximum power
output:
For low volume levels, the power savings
are active. If you increase the volume
level, the power savings are switched off
automatically, so you can enjoy
maximum output power without
Auto:
distortion.
If the volume is set to a high level but no
input signal is detected for more than 2
minutes, this unit will enable power
savings. When an input signal is detected
again or the input source is changed, this
unit will automatically turn off power
savings again at high volume levels.
Off
No power savings.
(Default):
Front panel Display
Playback Settings
0 When the unit is switching between the different power saving states in "ECO
Mode: Auto", you may notice a click noise from the inside of this unit, this is
normal.
0 If content is paused for more than 2 minutes and playback is resumed from the
same source at these high volume levels, there may be short delay before
maximum power is restored.
0 "ECO Mode" can also be switched by pressing ECO G on the remote control
unit.
139
Rear panel
Tips
Remote Index
Appendix