Items Needed For Installation - Rinnai M Series Installation And Operation Manual

•
Ensure the wall is of sufficient
strength to support the weight of the
boiler, piping and any other
components needed for installation;
if it is not, please reinforce the wall as
appropriate.
•
Operating limits of the boiler:
Maximum boiler set
point temperature:
Maximum operating
pressure:
Maximum allowable
working temperature
ASME:
Maximum allowable
working pressure
ASME:
DO NOT
DO NOT install the boiler in an area
where water leakage of the unit or
connections will result in damage to
the area adjacent to the appliance
or to lower floors of the structure.
When such locations cannot be
avoided, it is required that a
suitable drain pan, adequately
drained, be installed under the
boiler. The pan must not restrict
combustion air flow.
DO NOT install the boiler in an area
with negative air pressure.
DO NOT obstruct the flow of
combustion and ventilation air.
DO NOT use substitute parts that
are not authorized for this boiler.
DO NOT install the boiler on
carpeting.
16
185°F (85°C)
45 psi (3.1 bar)
210°F (99°C)
45 psi (3.1 bar)
Gather the recommended tools and parts
before starting installation.
Items Needed
•
Low loss header or closely spaced
tee
•
Expansion tank for a closed heating
system
•
CH System Air Separator
•
Standard tools for central heating,
gas fitting, plumbing and electrical
wiring.
•
Combustion analyzer (intended for
use with condensing boilers)
•
Digital manometer capable of
reading both positive and negative
pressure
•
Digital multimeter capable of
reading microamps
•
pH digital meter or test strips
•
For wall mounting bracket
installation:
−
Level
−
Screws (use appropriate screws
for type of wall construction)
Other Items You May Need
•
Hand truck with fastening belt
•
Boiler toolkit (optional accessory for
boiler service. See section "3.6
Accessories" for more information.)
Rinnai M-Series Condensing Boiler Solo Manual