Adjusting Frequency Step And Detection Mode; Adjusting The Frequency Step; Adjusting The Detection Mode - Sony ICF-SC1 Operating Instructions (primary manual) Operating Instructions Manual

Adjusting frequency step and
detection mode
You can adjust the frequency step and the detection mode
when you are in the Manual Mode.

Adjusting the frequency step

1
If you are in the Scanning Mode, press SCAN to enter
the Manual Mode.
Press STEP.
2
With each press, the frequency step changes as
follows.
AM, NFM:
5k + 70k + 12.5k -, 25k --, 50k -, 100k

Adjusting the detection mode

1
If you are in the Scanning Mode, press SCAN to enter
the manual mode.
2 Press MODE.
With each press, the detection mode changes as
follows.
AM 4 NFM + WFM
Notes
*You cannot adjust the frequency step and the detection mode
when you are in the Scanning Mode.
*The changes you have made in frequency step or detection mode
are effective only in the current band. When you switch to a
different band, the frequency step and detection mode will
return to default (see "Frequency range of the bands", page 10).
*If the current frequency is not a step frequency when you change
the frequency step, the frequency will automatically change to a
step frequency.
*If you have changed the detection mode to WFM when you are
in AM or NFM with the frequency step set to 25 kHz or less, the
frequency step will automatically change to 50 kHz. If the
current frequency is not a step frequency, it will automatically
change to a step frequency.
31