Using The Remote Control - Sony SAT-A4 Operating Instructions (primary manual) Operating Instructions Manual

Using the Remote Control

The FUNCTION buttons flash to indicate
which component the remote control is set
to operate.
SAT-A4 Remote Control
Outside Panel (SAT-A4)
POWER
MUTING
SLEEP CABLE TV
FUNCTION CABLE TV
POSITION AUDIO SWAP
+
CH
-
TV/VIDEO TV/SAT JUMP
1
2
4
5
7 8
DISPLAY
ENTER
0
INDEX CATEGORY GUIDE
MENU
VOL
EXIT
S
SATELLITE
RECEIVER
After you've installed the batteries and programmed the remote
control, use these procedures to operate your system components:
1
Select the component that you want to use: To operate a cable box,
TV, or the Digital Satellite Receiver, press the corresponding
FUNCTION button.
SAT-A4 Only : To operate a VCR or laserdisc player, open the lid on
the remote control and set the slide switch to the position that you
set for the component.
2
Aim the remote control at the component.
3
Press the POWER button of the component to turn it on and off.
To control other functions of the component, see the table that follows.
Note
Buttons described in the following table can operate components other than the
Digital Satellite Receiver only if you've programmed the remote and the
component supports the function described. See page 85 for instructions on
programming the remote.
SAT
Button
SAT
MUTING
PIP
OFF
FAVORITE
SLEEP
3
CABLE
6
9
FUNCTION
CH
PAGE
POSITION
RM-Y800
Operates Description
TV Mutes the volume. Press again to restore the
volume.
TV Automatically turns off the TV, after the time
period that you specify.
CABLE: Turns the cable box on and off.
POWER
SAT
TV
TV: Turns the TV on and off.
SAT: Turns the Digital Satellite Receiver on and
off.
CABLE: Puts the remote in cable mode. In cable
CABLE TV SAT
mode, the remote operates your cable box.
TV: Puts the remote in TV mode. In TV mode, the
remote operates your TV.
SAT: Puts the remote in SAT receiver mode. In
SAT mode, the remote operates your Digital
Satellite Receiver. To switch from the TV to SAT
mode, press the SAT FUNCTION button, and
then press the TV/SAT button.
Only works with Sony TVs.
AUDIO SWAP PIP
+
POSITION: Changes the PIP position.
CH OFF
-
AUDIO: Swaps the audio between PIP and the
SWAP: Swaps the PIP picture and the main
+/–: Changes the PIP channel.
PIP: Turns PIP on.
OFF: Turns PIP off.
main picture.
picture.
81