Phantom power (For wired version) The 2028 is designed to apply its full specifications at the standard +48 volt phantom power (± 4 V) but will work at lower supply voltages with reduced specifications.
Page 3
When remounting, take care to tighten the grid firmly, which secures the inner pop filter properly. Accessories included DUA0415 Clip for 2028 Vocal Microphone Replacement parts DUA0410B Grid – including outer black metal mesh and inner foam windscreen DUA0411 Inner Cylindrical Pop Filter...
So keep in mind that the low-frequency level will change according to the distance the mic is to the mouth. The mic has been designed and factory fine-tuned for this. The 2028 is intended to be flat at 12 cm (4.7 in).
Page 6
2028 Vocal Microphone Specifications (Measured with wired DPA Handle) Directional pattern Supercardioid Principle of operation Pressure gradient Cartridge type Pre-polarized condenser Frequency range 20 Hz - 20 kHz Frequency range, ±2 dB, at 12 cm (4.7 in) 100 Hz - 16 kHz. Permanent 3rd order low-cut filter at 80 Hz Sensitivity, nominal, ±3 dB at 1 kHz...
Frequency response Typical on-axis frequency response of 2028 Vocal Microphone measured at 12 cm (4.7 in). Polar pattern Service & repair If you are not satisfied with the characteristics exhibited by this product, please go to dpamicrophones.com/service for instructions. Warranty The 2028 Vocal Microphone is covered by a two-year limited warranty.
Page 8
Tel +1 303-485-1025 Tel: +852 2617 9990 info@dpamicrophones.com info-usa@dpamicrophones.com info-apac@dpamicrophones.com UK Sales Office German Sales Office Sound Network DPA Microphones Germany GmbH Unit 430 Highgate Studios, Grüneburgweg 58-62 53-79 Highgate Road 60322 Frankfurt am Main London NW5 1TL Germany United Kingdom Tel.