Troubleshooting - FujiFilm Instax mini LiPlay User Manual

Troubleshooting

Please check the following items before considering a problem to
be a malfunction. If the problem persists even after taking action,
please contact our service center for repair or visit the website
below.
FUJIFILM website: http://www.fujifilm.com/
If the following problem occurs���
Problem Possible causes and solutions
I cannot turn on The battery may be exhausted. Please
the camera. charge the camera.
The battery is If you use the camera in a very cold
exhausted environment, the battery will drain quickly.
quickly. Please keep the camera warm before
shooting.
Camera shuts The battery level may be low. Please charge
down during the camera.
use.
Charging does • Make sure that the USB power adapter
not start. plug is properly connected to the power
outlet.
• Turn off the camera when charging it. If
power is on camera will not charge.
It takes too long At low temperatures, charging may take
to charge. some time.
The self-timer Charge the battery in a temperature range of
lamp flashes +5 °C to +40 °C. If you cannot charge the
while charging. battery within this range, please contact our
support center.
I cannot shoot • Make sure that the power is on.
when I press the • If the battery level is low, please charge
shutter button. the camera.
• If the internal memory or memory card is
full, insert a new memory card or delete
unnecessary images.
• Use a memory card formatted with this
unit.
• If the contact surface of the memory card
(gold part) is dirty, wipe it with a soft, dry
cloth.
• The memory card may be broken. Please
insert a new memory card.
I cannot focus Use the AF/AE lock to shoot subjects that are
the camera. difficult to focus on.
The flash does Check that the suppressed flash setting has
not fire. not been selected. Select a setting other
than the suppressed flash setting.
Even though the • Check that you are not too far from the
flash fired, the subject. Please shoot within the flash
image is dark. range. Approximately 50 cm to 1.5 m.
• Hold the camera correctly so that you do
not obstruct the flash with your fingers.
22
Problem Possible causes and solutions
The image is • If the lens has dirt on it such as
blurred. fingerprints, clean the lens.
• Make sure that the AF frame is green
before taking a photo.
The camera • There may be a temporary malfunction.
does not work Please press the reset button. If it still does
properly. not work properly, please contact our
repair service center for repair.
• The battery may be exhausted. Please
charge the camera.
The film pack • Please use FUJIFILM instant film "INSTAX
does not load or mini" (other films cannot be used).
does not load • Align the yellow mark on the film pack
smoothly. with the yellow alignment mark on the
camera body to load the film.
The film does • The film may be misaligned due to shocks
not unload. such as vibration or dropping. Please load
a new film pack.
• If the film is jammed, turn off the camera
and turn it on again. If the problem
persists, remove the jammed film and
then load a new film pack.
Some or all of Do not open the film door until all film
the finished exposures have been used. Unexposed film
prints are white. will be prematurely exposed if the door is
opened. Prematurely exposed film will be
white with no images.
The print is • Do not shake, bend, fold or hold the print
uneven. immediately after it is printed.
• Do not obstruct the film ejection slot.