Assembling / Disassembling; Circuit Diagram - Makita TW100D Series Technical Information

R
epair

[3] ASSEMBLING / DISASSEMBLING

[3]-4. Replacing Anvil
(1) Disassemble Hammer case complete by steps drawn in Figs. 2 to 5.
Note: It is not necessary to disassemble Hammer case section when the only Ring spring 7 has a damage.
Skip the above steps.
(2) Remove Ring spring 11 from the groove of Anvil using 1R004 carefully.
(3) Set New Ring spring 11 in place as drawn in Fig. 13.
Note: Ring spring 11 is expanded through the setting process, and therefore, press it using Pliers (Fig. 14)
and then insert and remove 1R222 (or Socket bit for 9.5mm square shank wrench) several times until
Ring spring 11 is completely fit into the groove. (Fig. 15)
Fig. 13
Slide Ring spring 11 into the groove
of Anvil from the horizontal side.
Pliers
C
ircuit diagram
Fig. D-1
Color index of lead wires' sheath
Black
Red
White
Fig. 14
groove on
Anvil
Terminal
Fig. 15
Pliers
M1
Switch
M2
Connector
P 5/ 6
1R222
red marking
DC motor
LED