SPECIFICATIONS Model: TW140D Fastening capacities Standard bolt M8 - M16 High tensile bolt M6 - M12 Square drive 9.5 mm No load speed 0 - 2,600 min Impacts per minute 0 - 3,200 min Overall length 161 mm Rated voltage D.C.
medication. A moment of inattention while oper- SAFETY WARNINGS ating power tools may result in serious personal injury. Use personal protective equipment. Always General power tool safety warnings wear eye protection. Protective equipment such as a dust mask, non-skid safety shoes, hard hat or WARNING: hearing protection used for appropriate conditions Read all safety warnings, instruc- will reduce personal injuries.
Page 4
Do not use the power tool if the switch does Follow all charging instructions and do not not turn it on and off. Any power tool that cannot charge the battery pack or tool outside the be controlled with the switch is dangerous and temperature range specified in the instruc- must be repaired.
To remove the battery cartridge, slide it from the tool SAVE THESE INSTRUCTIONS. while sliding the button on the front of the cartridge. To install the battery cartridge, align the tongue on the CAUTION: Only use genuine Makita batteries. battery cartridge with the groove in the housing and slip Use of non-genuine Makita batteries, or batteries that it into place. Insert it all the way until it locks in place have been altered, may result in the battery bursting with a little click. If you can see the red indicator on the causing fires, personal injury and damage. It will upper side of the button, it is not locked completely. also void the Makita warranty for the Makita tool and charger. CAUTION: Always install the battery cartridge fully until the red indicator cannot be seen.
Indicating the remaining battery Switch action capacity Only for battery cartridges with the indicator ► 1 . Switch trigger CAUTION: Before installing the battery car- ► 1 . Indicator lamps 2. Check button tridge into the tool, always check to see that the switch trigger actuates properly and returns to Press the check button on the battery cartridge to indi- cate the remaining battery capacity. The indicator lamps...
Reversing switch action Installing or removing impact socket ► 1 . Reversing switch lever ► 1 . Impact socket 2. Square drive To install the impact socket, push it onto the square CAUTION: Always check the direction of drive of the tool until it locks into place. rotation before operation.
Proper fastening torque for high tensile bolt OPERATION N•m (kgf•cm) CAUTION: Always insert the battery cartridge all the way until it locks in place. If you can see the (1430) red indicator on the upper side of the button, it is not locked completely. Insert it fully until the red indicator cannot be seen. If not, it may accidentally fall out of (1224) the tool, causing injury to you or someone around you.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regard- ing these accessories, ask your local Makita Service Center.