Troubleshooting - Sony VPL-VW60 Operating Instructions (VPL-VW60) Operating Instructions Manual

Troubleshooting

If the projector appears to be operating erratically, try to diagnose and correct the problem
using the following instructions. If the problem persists, consult with qualified Sony
personnel.
Power
Symptom
The power is not turned on.
Picture
Symptom
No picture.
The picture from the
INPUT A connector is
colored strange.
The picture from the
VIDEO INPUT or
S VIDEO INPUT
connector is colored
strange.
The color gradation of the
dark area or the bright area
of the picture from the
HDMI 1 or HDMI 2
connector becomes
unclear.
The picture is too dark.
The picture is not clear.
54
Cause and Remedy
c After about one minute, turn the power on.
c Close the lamp cover securely, then tighten the screws securely.
(1 page 58)
c Close the filter holder securely. (1 page 60)
c Check warning indicators. (1 page 56)
Cause and Remedy
c Check that the proper connections have been made.
(1 page 17)
c Select the input source correctly using the INPUT button.
(1 page 27)
c Set the computer signal to output from an external monitor.
c Set the computer signal to output only to an external monitor.
c Select "Computer," "Component" or "Video GBR" for "Input-A
Signal Sel." on the Setup
signal. (1 page 47)
c Select "Computer," "Component" or "Video GBR" for "Input-A
Signal Sel." on the Setup
signal. (1 page 47)
c Adjust the picture of the Picture
c Set "Color System" in the Setup
system being input. (1 page 47)
c The color gradation of the dark area or the bright area may
become unclear when a signal other than those from HDMI
standard is input. Adjust the "Brightness" and the "Contrast" in
the Picture menu. (1 page 41)
c Adjust the "Contrast" or "Brightness" of the Picture
properly. (1 page 41)
c Adjust the focus. (1 page 24)
c Condensation has accumulated on the lens. Leave the projector
for about two hours with the power on.
menu according to the input
menu according to the input
menu. (1 page 40)
menu to match the color
menu