General Operation Of - Toshiba TLP710E Technical Training Manual

3-2. General Operation of Each IC and
Signal Flow
3-2-1. Input Amplifiers (Q408, Q508 and Q608)
These circuits amplify the video signal to the input level
adequate for the gamma process IC (Q701) in the next stage.
The internal circuit possesses the clamp circuit, amplifier
circuit, which controls the gain by the DC voltage sent from
the 8 bit DA for electronic variable resistor (Q905), and
o u t p u t c i r c u i t .
For the input terminals, 16 pins are used, for the output
terminals, 8 pins and for gain control terminals, 4 pins.
3-2-2. Gamma Process IC (Q701)
Fig. 3-2-1 shows the gamma process IC (Q701).
Fig. 3-2-1 Block diagram of gamma process IC (Q701)
Fig. 3-2-2 Signal path
This IC functions to clamp, process gamma and amplify
each of RGB signals. The main features are as follows;
• Gamma circuit: Adjusts gain and position in three
• F c h a r a c t e r i s t i c : 100 MHz
• Through rate:
• Control:
This IC performs gamma control for the panels and make
output signals supplied to the alternation/sample & hold
ICs (Q401, Q402, Q501, Q502, Q601 and Q602) in the
next stage.
The signal path is shown in Fig. 3-2-2.
3-2
points (white side: 1, black side: 2)
for RGB each separate adjustment.
375
2
Carried out by I C.